Issue with Periodic Surfaces
Hello,
For the structure below, I get an issue if I mesh through the GUI (can't find periodic surface), but it goes smoothly via the command line. Any clue as to why this is happening? Thanks
h=10.0;
Point(1) = {-50.0,50.0,-10.0,h};
Point(2) = {50.0,50.0,-10.0,h};
Point(3) = {50.0,-50.0,-10.0,h};
Point(4) = {-50.0,-50.0,-10.0,h};
Line(1) = {1,2};
Line(2) = {2,3};
Line(3) = {3,4};
Line(4) = {4,1};
Line Loop(1) = {1,2,3,4};
Point(5) = {22.360679774997898,-22.360679774997898,-10.0,h};
Point(6) = {22.360679774997898,22.360679774997898,-10.0,h};
Point(7) = {-22.360679774997898,22.360679774997898,-10.0,h};
Point(8) = {-22.360679774997898,-22.360679774997898,-10.0,h};
Line(5) = {5,6};
Line(6) = {6,7};
Line(7) = {7,8};
Line(8) = {8,5};
Line Loop(2) = {5,6,7,8};
Plane Surface(1) = {1,2};
Extrude {0,0,20.0} { Surface{1};}
Physical Volume("Bulk") = {1};
Physical Surface("Boundary") = {37,41,45,49,50,1};
Physical Surface("Periodic_x_a") = {33};
Physical Surface("Periodic_x_b") = {25};
Periodic Surface {25} = {33} Translate {100.0,0.0,0};
Physical Surface("Periodic_y_a") = {29};
Physical Surface("Periodic_y_b") = {21};
Periodic Surface {21} = {29} Translate {0.0,100.0,0};
Edited by Giuseppe Romano