Question on structured grids and conformal mesh
Hi all,
I have a question on structured grids and conformal mesh.
For this purpose I have created a small script (attached) where I build two physical volumes (Body A and Body B) by grouping smaller volumes. The latter are generated using structured grids extruded from a set of adjacent squares (physical surface "Base surface", see picture below).
I need the mesh at the interface between Body A and B to be conformal. I think this should be guaranteed by the way I created them (using structured grids) but I'm not sure if it is sufficient.
Is this enough to achieve conformity or do I need to perform additional operations?
Thanks,
Marco